Iron 3 Oxide,Iron Lll Oxide,Ferric Oxide Red,Transparent Iron Oxide TINOX CHEMIE GMBH , https://www.tinoxglobal.com
Pneumatic diaphragm pump its commonly used in four materials: plastic, aluminum, cast iron, stainless steel, Teflon. The import of pneumatic diaphragm pump is a diaphragm, the following small series for a brief introduction to the use of imported pneumatic diaphragm pump and gas source requirements. Imported pneumatic diaphragm pump How to use Imported diaphragm pump As far as possible to import pneumatic diaphragm pump to be transported near the material. Minimize the length of suction tubing and the number of accessories. Do not reduce the caliber of the suction tube. For rigid pipe installation, the pump should be in the middle of the pipe section of a short hose, hose can reduce system vibration and strain. Dampers are recommended to further reduce the vibrations in the flow. Imported pneumatic diaphragm pump gas source pneumatic pump pressure should be less than 7bar. The capacity and pressure of the connected pump gas source should be sufficient to meet the design performance requirements. When the supply pipe is a rigid pipe, connect the pipe and pump with a hose shorter than 1/2-inch in diameter to reduce pipe strain. Gas pipes, regulators and filters shall not be supported by the air intake and other measures shall be taken. Failure to support the pipe will cause damage to the pump. A regulating valve should be installed to ensure that the air pressure does not exceed the recommended limits. The correct installation and use of the product is very important, the installation of pneumatic diaphragm pumps also need to pay enough attention. The above is the use of pneumatic diaphragm pump imports and gas source requirements, I hope for your help! This article is copyrighted industry interconnect (Xiamen) Co., Ltd. All are welcome to reprint, please indicate the source and author of: Asian pumps Network Editor: lindj (QQ / micro-channel:) starting: http: //beng.liuti.cn / (Service Hotline:)