Conventional word processing commands in Zhongwang CAD can only distribute text in a straight line, but sometimes CAD designers need to discharge text along the path. In order to discharge the text along the curve distribution (such as circular distribution), it is difficult to use only the word processing command; Zhongwang CAD provides the ET extension tool, and there is a curved text (Arctext) in the text tool, which is very convenient. Handle curved text. The details are as follows. The following describes a method for writing text along a spline curve or a polyline in Zhongwang CAD. At this point we need to use the fixed divide command, which will make the problem easier. The specific implementation steps are as follows: 1. First use the text creation command (Text) to write 1 character, the insertion point is defined as the center or the bottom center. The above character is defined as a block A by a block definition command (Block), and the insertion point of the block is selected as the insertion point at the time of character creation. As shown below 3. Use the Spline command to draw the path of the text distribution (if you are using polyline or circular distribution, use Pline or Circle to draw a polyline or a circle). Wooden Door,Mdf Door,Solid Wood Door Steel Door,Toilet doors,Wood Door Co., Ltd. , http://www.steeldoors-manufacuturer.com
Then we look at the picture, the arc text requires that the object must be an arc, then if you want to write text along the polyline or spline, the arc text can not be reached, then what should we do? 
