News Related Keywords: No tags.

In order to ensure that no personal danger occurs in the rescue work, you must understand the dangers that will be encountered and learn how to prevent them, ie "skills." It is the basic points and techniques that rescue workers need to master.
Rescue work was never accomplished by one person. Teamwork can greatly enhance the rescue effect. The experience or skills of everyone in the team is very useful. The disaster brings together strangers and saves lives in unison. It is an important first step to take a moment to understand the skills and skills of each member of the team. A strong team depends on the diversity of its members and their ability to use their knowledge and experience.
Rescuers should have knowledge about ropes, knots and strapping. They should know how to use jacks and levers, chain lifts and ladders. They want to learn how to use the material found on the site to support the building and learn how to handle casualties. Medical rescue courses must be mastered.
At the same time, you also need to learn how to avoid harming yourself while helping others. Therefore, there is a need to learn how houses are built and collapsed; it is necessary to learn how to work as safely as possible in collapsed buildings, rubble, and debris.
In any street, new houses have been built and old houses have been demolished. Pay attention to observe and learn how the house was built.
In order to experience how to work in the crevices, you can use old wood to build some rafts to simulate the collapsed house. Lean them against the wall and build the required gap. You can also add some crates to the above to increase the authenticity. With two such rafts, you can simulate any kind of gap. As long as there is a little imagination, it does not cost a lot of money. Before you practice, make sure it doesn't slip and cause harm.
Rescuers must master how to use whatever they can reach. Learn to play on the spot. Lists, including neighbors' tools, especially ladders, car jacks, axes, carpentry tools, blankets, ropes, emergency equipment , garden tools, flashlights, helmets, and gloves. In the middle of a sudden, you need to know where to get these tools.

5 series aluminum alloy is a common aluminum alloy plate series,The main element is Mg, and the content of Mg is between 3-5%. It can also be called called Al-Mg Alloy,. The main characteristics are low density, high tensile strength and high elongation.

In the same area, the weight of Al-Mg alloy is lower than other series, so it is often used in aviation, such as aircraft fuel tank. It is also widely used in conventional industry.

The processing technology is continuous casting and rolling, belonging to the hot rolled aluminum plate series, so it can do the deep processing of oxidation. In our country, 5 series aluminum plate is one of the mature aluminum plate series.

 

 

Typical Alloy

Typical Temper

Specification

Thickness

Width

5005 5052 5083 5086 5182 5754 5154 5454 5A05 5A06

 

O/H111 H112 H116/H321 H12/H22/H32 H14/H24/H34 H16/H26/H36 H18/H28/H38 H114/H194

≤170mm   (For tread plate, Thickness≤6mm)

1100

1150

1200

1250

1300

1350

1500



 

Typical Application:  Marine Grade Plate, Ring-Pull Can End Stock, Ring-Pull Stock, Automobile Body Sheets, Automobile Inside Board, The Protective Cover On Engine

5 Series Alloy

Pattern Plate,Aluminium Tread Sheet,Shipping Plate,Five-Bar Aluminium Tread Plate

La Ya Aluminium products Co.,Ltd. , https://www.layametal.com

Posted on