We produce a range of Metric Hydraulic Fittings of filuid connectors. Hydraulic Fittings are available straight, male&female, elbows 45°&90° with swivel nuts and o-rings seal to suit SAE100 R1AT, R2AT, wire braided no skive Hydraulic Hose , 4SP spiral skive Rubber Hose . Metric Hose Fittings conform to DIN&SAE standards. Inculde:
Flat Seal Hydraulic Fitting
Standpipe Hose Fitting
Applications:
Metric Hose Fittings,Hose Fittings,Hose Pipe Fittings,Hydraulic Pipe Fittings SHIJIAZHUANG TOPA TRADING CO., LTD. , https://www.topahydraulic.com
74°Cone Seal Hydraulic Hose Fitting
24°Cone O-ring Seal Light Hydraulic Hose Fitting
24°Cone O-ring Seal Heavy Hose Fitting
• Mobile Hydraulics
• Marine Hydraulics
• Mining Industry
• General light Industry
The reason why many multi-stage slurry pump inefficient, frequent failures, is entirely due to the paralysis of the installer caused. Today, Xiao Bian to share for you to install multi-stage slurry pump steps and points, hoping to help you! Multi-stage slurry pump installation points, multi-stage slurry pump installation steps 1. Check the installation of multi-stage Slurry pump mechanical seal models, specifications are correct. 2. Check the size of the parts associated with the installation of the mechanical seal and mechanical seal accuracy, geometric accuracy and correlation with the technical requirements. (1) Allowable radial runout of the shaft (or sleeve) where the mechanical seal is installed, surface finish of the shaft (or sleeve), and tolerance of outside diameter dimensions. (2) seal cavity and gland positioning end face of the shaft (or sleeve) centerline vertical tolerance tolerance. (3) The end of the shaft (or sleeve) on which the moving ring seal is mounted, and the chamfer and finish of the end structure of the housing bore for the mechanical seal. (4) The axial displacement of the mechanical seal shaft when working. 3. In the process of installing multi-stage slurry pump, keep clean, do not allow the tool to knock the sealing element to prevent damage and damage. 4 installation, moving, static ring surface should be coated with a layer of clean oil and turbine oil. Auxiliary seals (including moving ring seals and static ring seals) are also to be applied with a clean layer of engine oil or turbine oil before installation to ensure smooth installation. 5. The static ring seal set in the back of the static ring, into the sealed end cap, pay attention not to hurt the static end face, to ensure the static end face and end cap vertical centerline, and pay attention to the back of the static ring to prevent trough to Alignment anti-sales, but can not touch. 6. Rotating part of the mechanical seal, relying on the two fixed screws on the spring seat and the shaft fixed, tighten the screws, to ensure the working length of the spring. (Editor: Huang Nengwen QQ:)